cisco 2960g ip&mac&port绑定(2)
Switch#Switch#sh ip int g0/1GigabitEthernet0/1 is up, line protocol is upInboundaccess list is IP01Switch#Switch#sh ip int g0/48GigabitEthernet0/48 is up, line protocol is upInboundaccess list is not setSwitch#Switch#sh int g0/1 ?accounting Show interface accountingcapabilities Show interface capabilities informationcontroller Show interface status, configuration and controller statuscounters Show interface counterscrb Show interface routing/bridging infodampening Show interface dampening infodebounce Show interface debounce time infodescription Show interface descriptionetherchannel Show interface etherchannel informationfair-queue Show interface Weighted Fair Queueing (WFQ) infoflowcontrol Show interface flowcontrol informationirb Show interface routing/bridging infomac-accountingShow interface MAC accounting infompls-exp Show interface MPLS experimental accounting infomtu Show interface mtuprecedence Show interface precedence accounting infoprivate-vlan Show interface private vlan informationpruning Show interface trunk VTP pruning informationrandom-detect Show interface Weighted Random Early Detection (WRED) inforate-limit Show interface rate-limit infostats Show interface packets & octets, in & out, by switching pathstatus Show interface line statussummary Show interface summaryswitchport Show interface switchport informationtransceiver Show interface transceivertrunk Show interface trunk informationvlan Show interface vlan information| Output modifiers<cr>Switch#Switch#sh vlanVLAN Name Status Ports---- -------------------------------- --------- -------------------------------1 default active Gi0/475 VLAN0005 active Gi0/1, Gi0/2, Gi0/3, Gi0/4, Gi0/5, Gi0/6, Gi0/7, Gi0/8, Gi0/9, Gi0/10 Gi0/11, Gi0/12, Gi0/13, Gi0/14, Gi0/15, Gi0/16, Gi0/17, Gi0/18, Gi0/19 Gi0/20, Gi0/21, Gi0/22, Gi0/23, Gi0/24, Gi0/25, Gi0/26, Gi0/27, Gi0/28 Gi0/29, Gi0/30, Gi0/31, Gi0/32, Gi0/33, Gi0/34, Gi0/35, Gi0/36, Gi0/37 Gi0/38, Gi0/39, Gi0/40, Gi0/41, Gi0/42, Gi0/43, Gi0/44, Gi0/45, Gi0/461002 fddi-default act/unsup1003 token-ring-default act/unsup1004 fddinet-default act/unsup1005 trnet-default act/unsupVLAN TypeSAID MTU Parent RingNo BridgeNo StpBrdgMode Trans1 Trans2---- ----- ---------- ----- ------ ------ -------- ---- -------- ------ ------1 enet100001 1500- - - - - 0 05 enet100005 1500- - - - - 0 01002 fddi101002 1500- - - - - 0 01003 tr 101003 1500- - - - - 0 01004 fdnet 101004 1500- - - ieee - 0 01005 trnet 101005 1500- - - ibm- 0 0Remote SPAN VLANs------------------------------------------------------------------------------Primary Secondary Type Ports------- --------- ----------------- ------------------------------------------Switch#Switch(config)#int g0/9Switch(config-if)#?Interface configuration commands:arp Set arp type (arpa, probe, snap) or timeoutauto Configure Automationbandwidth Set bandwidth informational parametercarrier-delay Specify delay for interface transitionscdp CDP interface subcommandschannel-group Etherchannel/port bundling configurationchannel-protocol Select the channel protocol (LACP, PAgP)dampening Enable event dampeningdefault Set a command to its defaultsdelay Specify interface throughput delaydescription Interface specific descriptiondot1x Interface Config Commands for IEEE 802.1Xdown-when-looped Force looped interface downduplex Configure duplex operation.ethernet Ethernet interface parametersexit Exit from interface configuration modeflowcontrol Configure flow operation.help Description of the interactive help systemhold-queue Set hold queue depthip Interface Internet Protocol config commandskeepalive Enable keepalivelacp LACP interface subcommandslink Configure Linkload-interval Specify interval for load calculation for an interfacelogging Configure logging for interfacemac MAC interface commandsmacro Command macromax-reserved-bandwidthMaximum Reservable Bandwidth on an Interfacemdix Set Media Dependent Interface with Crossovermls mls interface commandsmvr MVR per port configurationno Negate a command or set its defaultspagp PAgP interface subcommandspriority-queue Priority Queuequeue-set Choose a queue set for this queuermon Configure Remote Monitoring on an interfaceservice-policy Configure QoS Service Policyshutdown Shutdown the selected interfacesnmp Modify SNMP interface parameterssource Get config from another sourcespanning-tree Spanning Tree Subsystemspeed Configure speed operation.srr-queue Configure shaped round-robin transmit queuesstorm-control storm configurationswitchport Set switching mode characteristicstimeout Define timeout values for this interfacetransmit-interface Assign a transmit interface to a receive-only interfacetx-ring-limit Configure PA level transmit ring limitudld Configure UDLD enabled or disabled and ignore global UDLD settingSwitch(config)#Switch(config)#exitSwitch#
页:
[1]