CISCO升级与恢复方案
rommon 2 > confreg do you wish to change the configuration? y/n : yenable "diagnostic mode"? y/n : n
enable "use net in IP bcast address"? y/n : n
disable "load rom after netboot fails"? y/n : n
enable "use all zero broadcast"? y/n : n
enable "break/abort has effect"? y/n : n
enable "ignore system config info"? y/n : n
change console baud rate? y/n : y
enter rate: 0 = 9600, 1 = 4800, 2 = 1200, 3 = 2400
4 = 19200, 5 = 38400, 6 = 57600, 7 = 115200 : 7
change the boot characteristics? y/n : y
enter to boot:
0 = ROM Monitor
1 = the boot helper image
2-15 = boot system
: 0
Configuration Summary
enabled are:
load rom after netboot fails
console baud: 115200
boot: the ROM Monitor
do you wish to change the configuration? y/n : n
You must reset or power cycle for new config to take effect
rommom 2 > reset
页:
[1]