CISCO IPV6隧道配置
需求：将两个孤立的IPV6网络通过IPV4连接起来使用技术：IPV6隧道技术
要求：R1和R2这两台边缘路由器必须支持IPV6
R1配置如下:
Ipv6 unicast-routing #IPV6路由单播
Interface loopback 0
No ip address
Ipv6 address 2000::/64 eui-64
Ipv6 enable
Ipv6 ospf network point-to-point #指定OSPF网络类型
Ipv6 ospf 100 area 0 #将接口加入OSPF100进程，区域为0
Interface FastEthernet 0/0
Ip addr 10.10.10.1 255.255.255.0
Duplex half
No cdp enable
#建立通道
Interface Tunnel 0
Ipv6 addr 2013:1:1:11::1/64
Ipv6 enable
Ipv6 ospf 100 area 0
Tunnel source FastEthernet 0/0 #指定通道源接口
Tunnel destination 10.10.10.2 #指定通道目标IPV4地址
Tunnel mode ipv6ip #指定通道模式为IPV6IP,即Manual
#IPV6 OSPF 配置
Ipv6 router ospf 100
Router-id1.1.1.1
log-addjacency-changes
R2配置如下:
Ipv6 unicast-routing
Interface loopback 0
No ip address
Ipv6 address 2001::/64 eui-64
Ipv6 enable
Ipv6 ospf network point-to-point
Ipv6 ospf 100 area 0
Interface FastEthernet 0/0
Ip addr 10.10.10.2 255.255.255.0
Duplex half
No cdp enable
#建立通道
Interface Tunnel 0
Ipv6 addr 2013:1:1:11::2/64
Ipv6 enable
Ipv6 ospf 100 area 0
Tunnel source FastEthernet 0/0
Tunnel destination 10.10.10.1
Tunnel mode ipv6ip
#IPV6 OSPF 配置
Ipv6 router ospf 100
Router-id2.2.2.2
log-addjacency-changes
页:
[1]