cisco 两个设备之间测试吞吐量的一个方法

xiaodouya33

　　两个cisco AIR-BR1310G-A-K9-R设备，测试其之间可以达到的吞吐量。
　　
　　一边ping包，
　　WJ-Bridge-D2#ping 10.10.192.10 repeat 3000 time 0 si 9000
　　Type escape sequence to abort.
　　Sending 3000, 9000-byte ICMP Echos to 10.10.192.10, timeout is 0 seconds:
　　......................................................................
　　......................................................................
　　......................................................................
　　......................................................................
　　......................................................................
　　
　　
　　另一边过几秒查看一次，当达到最高时，就是近似它的吞吐量了。
　　D2-Bridge-WJ#sh int dot11Radio 0
　　Dot11Radio0 is up, line protocol is up
　　 Hardware is 802.11G Radio, address is 0007.0e7d.2370 (bia 0007.0e7d.2370)
　　 MTU 1500 bytes, BW 54000 Kbit, DLY 1000 usec,
　　>
　　 Encapsulation ARPA, loopback not set
　　 ARP type: ARPA, ARP Timeout 04:00:00
　　 Last input never, output 00:00:00, output hang never
　　 Last clearing of "show interface" counters never
　　 Input queue: 0/1127/0/0 (size/max/drops/flushes); Total output drops: 23115
　　 Queueing strategy: fifo
　　 Output queue: 0/30 (size/max)
　　 30 second input rate 44000 bits/sec, 60 packets/sec
　　 30 second output rate 59000 bits/sec, 60 packets/sec
　　 609068 packets input, 127665404 bytes, 0 no buffer
　　 Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
　　 0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
　　 0 input packets with dribble condition detected
　　 727710 packets output, 737221567 bytes, 0 underruns
　　 37745 output errors, 0 collisions, 2 interface resets
　　 0 babbles, 0 late collision, 0 deferred
　　 0 lost carrier, 0 no carrier
　　 0 output buffer failures, 0 output buffers swapped out
　　D2-Bridge-WJ#